Tools @ Height Slugging Wrench Retainer For 7/8" Studs

by Williams

Tools @ Height Slugging Wrench Retainer For 7/8" Studs

Slugging Wrench Retainers thread onto the end of the stud over the slugging wrench to ensure the wrench stays affixed to the fastener. A spring loaded plate allows for easy adjustment of the wrench without having to unscrew the retainer. Increased productivity and safer operation by eliminating the need for a second worker to hold and slugging wrench in place. Available in 1 sizes, marked with stud sizes (not hex sizes). Configured to work with offset and straight handle slugging wrenchesTorques in both clockwise and counterclockwise directions. Battery saving auto-shutoff after two minutes. COMPUTORQ 3 remembers last unit and torque setting selected. Audible tone sounds when set torque value is reached, if the set torque value is exceeded, an alarm tone will sound. 3 color LED light bar: YELLOW LED indicates approaching desired torque setting; GREEN LED indicates desired torque value is reached; RED LED indicates fastener was overtorqued, loosen and retighten. When desired torque value is reached, display will hold value and flash for ten seconds. COMPUTORQ 3 will operate in any of four torque units, foot pounds (ft. lbs.), inch pounds (in. lbs.), newton meter (Nm) or kilogram centimeter (kg. cm.). ACCURACY: ±2% CW of readings from 2% to 1% of full scale; ±3% CCW of readings from 2% to 1% of full scale. N.I.S.T. traceable certificate of calibration included