Details
Features (cont.)::
.
Determine which grippers will be used, install and tighten grippers hand tight. If VersaGrips™ are being used to grip round stock, place in outboard bores. Do not tighten screws at this point. Tighten vise lightly onto workpiece allowing jaws to cent
Features (cont.):-2:
Any size t-nuts can be utilized. We provide 16mm t-nuts (most popular size) which also fits 5/8 t-slots.
Gripper configurations
Round stock: use 4 VersaGrips™, two in each outboard bore. Adjust so all “points” make contact simultaneously. If small
Features (cont.):-3:
For additional holding force, loosen vise handle which will eliminate any jaw lift that may have occurred and depending on amount of torque can increase pressure to over 9,000 lbs.
T-Slot & Grid table application
Using vertical counter bores on outboard
Features::
Tall Vise Jaws/Towers
These Vise Jaws/Towers are designed to mount directly to your 4 or 6 inch vise elevating your workpiece into the 5 axis envelope. You already have the platform therefore this becomes a very simple and low cost solution. This is the o
KIT/SET CONTENTS:
2 Jaws, 5 TalonGrip™, 4 VersaGrip™, 2 Pitbull®, 6 Support Bolts, 4 Mounting Bolts, 4 T-nuts
Manufacturer Product Code:
MATERIAL SAFETY SHEET REQUIRED:
Package/UOM weight (lbs):
TARIFF CLASSIFICATION NUMBER:
Manufactured By:
Mitee-Bite Products
